PING TESTER - NETWORK IP TEST TOOL

VERIFY CONNECTIVITY ACROSS A LAN OR WAN - FULL 10/100 Mbps PING CAPABILITY

Network maintainers commonly run PING tests from laptop computers to verify connectivity when troubleshooting a problem. PING TESTER replaces expensive and fragile laptop computers with an affordable and rugged test device.

PING TESTER incorporates four new major test functions:

10/100 baseTX Link identification; 10/100 PING capability; Ten programmable profiles (Source and Destination IP addresses, Gateway IP address and Subnet Mask) and setup from easy access keypad.

PING TESTER provides a comprehensive array of PING test capabilities that include PINGing a pre-stored list of IP addresses, PINGing a range of IP addresses, continuously PING an IP address up to 99 times and vary the PING packet length.

PING TESTER is a highly advanced test tool that fits in a shirt pocket. User interface with a two line LCD display and a 4X4 matrix keypad make the tester easy programmable and compact.

Applications

The PING TESTER is tool for quickly testing proper LAN operation after completing installation, addition or a Move. Trouble Calls are easily handled by verifying Link connection and running the comprehensive PING test. Remote Office Support can be provided by connecting the PING TESTER to the LAN at the remote office trouble point and then PING the unit over the Internet or Intranet.

Verify end-to-end operations prior to installing workstations using two units to PING each other.

Power

Four AA Alkaline Batteries (Included).

AC Adapter for Extend Operation.

Environment

Operating Temperature: 0° to 50°C

Display

16x2 Character display

Keypad

4x4 Matrix Keypad.

Connector Type

One RJ-45

Hardware Details

Our Hardware has the following configuration:

• ATMEL T89C51RD2 micro-controller with
  
  • 64 Kbytes on-chip Flash program/data Memory,
  • 256 bytes scratch pad RAM
  • 1 Kbytes expanded RAM (XRAM)
  • 2 Kbytes EEPROM
    
• Cirrus Logic Inc. CS8900A Ethernet Controller
• LANLED and LINKLED indicators
• AT24C04A 512 byte data EEPROM
• Socket DIL-08 to install additional EEPROM
• Microchip PIC16C505 micro-controller to provide In-circuit Programming of the main
• Flash micro-controller through the RS232 Serial Port
• RS232 Serial Port connector for In-circuit Programming and for data communications
• RJ45 connector for 10BASE-T Ethernet Port
• 10-pin connector for matrix and non-matrix keypads
• Dual-row 14-pin LCD connector (with software contrast adjustment for LCD)
• 20-pin Expansion connector for a variety of peripheral boards
• Single operating unregulated voltage 6 10 12VDC
• On-board 5 Volt regulator
• Dimensions are 2.35 X 2.40 inches (5.97 X 6.10 centimeters).
• Mounting holes of 0.138 inches (3.5 millimeters) are on four corners.
• 0° - 70° C operating, -40° - +85° C storage temperature range.

Ethernet

Trioz Tech has designed a C library to support full TCP/IP stack.

ARP, IP, ICMP, and TCP layers developed using CS8900 (Ethernet controller) allows to build many modern network applications easily. Our Hardware supports PING, TELNET (port 23) and HTTP (port 80) services. Trioz TCP/IP stack includes TCP engine. The engine supports the sliding windows, re-transmission and automatic closing of unused TCP connection.

IPX (Internetwork Packet eXchange)

IPX protocol will give you very fast and reliable Ethernet connection for your embedded applications. An efficient communication can be established from a PC to our hardware using IPX protocol.